Cpe installation guide

A firmware update can resolve issues that the previous firmware version may have and improve its current performance. Bug Fixes: 1. Notes: 1. Your device's configuration won't be lost after upgrading. Optimized the SSID scan process. Extended the SSL certificate validity to Bug Fixed: 1. Upgrade OpenSSL version from 0. Optimize the memory usage of web server. Assemble M25 cable gland 8.

Position Adjustment Find the location and best angle for getting the strongest signal from the base station. The default IP of the modem is Make sure the attached PC to this router is on the same subnet and has an IP address in the range between The login prompt will appear. Input the default username admin and password admin 4.

Use the Quick Start wizard for fast Internet connection setups. Time Zone configuration to GMT 6. After finishing the configuration, please make sure you changed the default admin login password and note it down.

Please be aware that mobile service providers may change their APN, Username and Password settings depending on the nature of your contract, so be advised to double-check with your service provider first if you are experiencing connection difficulties. APN name, Username and Password are the 3 fields needed to set up your mobile broadband connectivity.

Please do not change the remaining fields unless specified by your service provider. Once you have enabled SMS control and set up the password — maximum 10 characters — you can perform the following. Input the 4G installation site Postcode Click on the view on Google Map with Measure Tool Copy the Coordination Input the site address into Google Earth.

Use the Ruler tool draw a line from the installation site to the Mast which is Launch mobile phone Compass app and point the Outdoor 4G panel to Checking Line of sight - Right click on the line- select show elevation profile Troubleshooting 1. None of the LEDs are on when you turn on the Router. Check the connection between the adapter and the router. Follow the steps below to configure the device as Access Point mode:. Figure Selecting an Operation Mode.

Then, click Next. Click Next. You can keep the default settings or specify the parameters according to your need. For details, refer to Configure the Wireless Parameters. Figure Checking the Settings. Figure Searching for Upstream Wireless Networks.

Figure Selecting an Upstream Wireless Network. As for the wood walls or plasterboards, it should be no more than two layers. In the below figure, CPE-1 has a distance less than 15 meters from the wireless router, this is a correct installation location. As for CPE-3, there are several concrete walls between it and the router, which will significantly influence the wireless signal, it is necessary to adjust the position of CPE There are no significant angle requirements for installation, but we recommend not to set up the angle more than 60 degrees CPE-2 in the below figure is acceptable.

We recommend installing CPE on the same level or slightly higher than the router, and please avoid the ceiling. Imagine that the wireless router is located at the foot of a mountain, and CPE is at the top of the mountain, when you climb the mountain, it should be not steep, and easy to reach the top.

At the location planned to install CPE, please connect your phone to the wireless router and check if you are satisfied with the network performance. We recommend testing with your frequently used APPs. For example, watch online videos on YouTube, or check the image loading speed on Twitter or Instagram, which all depends on your own network behavior.

With this test, you will know the wireless environment and network performance of this location. Note: The above recommendations are based on the antenna parameters and test results in a specific environment, which can meet most of the usage scenarios. However, the recommendations are impossible to adapt to all kinds of environments due to complexity. We do not assume legal responsibility for the above recommendations.